I wish to assign a switch as follows: Position 1: All surfaces act as ailerons, all controlled by right stick. Position 2: 2 surfaces act as ailerons (controlled by stick) and 2 surfaces act as flapes (not moving with stick, set at ~15% bank). Position 3: same as pos-2 with different percentage of bank. All help will be apriciated. The failsafe servo positions are programmed using the button on the transmitter. To set this up, two phases are recommended. 1) With the plane on the ground, and servo positions neutral, throttle cut, hold down the transmitters bind/failsafe button until the transmitter beeps. This will set a reasonable default failsafe ready for the first flight Set up your Triple Rates and Exponential the quick and easy way with step-by-step instructions from World-Champion pilot Chip Hyde. Heat both sides evenly. I alternate (using a stop watch) 60 seconds on one side moving the heat side to side and then 60 seconds on the other side, moving up and down along the area to be bent. Keep the heat gun at least an inch from the plexi or you risk overheating an area and causing it to bubble. Remote Control FUTABA 7C-2.4GHZ Instruction Manual. 7-channel fasst radio control system for airplanes/helicopters (86 pages) Remote Control FUTABA 7PX User Manual. 2.4ghz system t-fhss sr (192 pages) Remote Control FUTABA 7PXR Instruction Manual. Telemetry system (204 pages) Remote Control FUTABA 7XC Instruction Manual. Re: Synchronizing 2 servos on a Futaba. just go to the funtion menu and set what ever channels you have the rudder plugged in to and change its label to rudder and check to make sure you have the propper stick asigned and trim asigned. Last edited by Josh Price; 07-18-2009 at 08:23 PM. Please feel free to contact the Futaba Service Center for assistance in operation, use and programming. Please be sure to regularly visit the 9C Frequently Asked Questions web site at www.futaba-rc.com\faq\faq-9c.html. This page includes extensive programming, use, set up and safety information on the 9C radio system and is updated regularly. 9.7K views 1 year ago. Join us as we sit down with our friend, and Futaba go-to man, Newbie Mike to show us how to set up telemetry within the Futaba system. We demonstrate how to set up The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter. Like the flight condition function of the transmitter, you can set up to 5 different data for the attitude holding force rate of the aircraft in AVCS mode by operating the switch from the transmitter, and switch between them. Set up one engine in the normal way with the Throttle Function. Set up throttle cut, idle down, exponential or throttle curves as required. Now connect the second engine to a spare channel and assign Fuel Mix in the Function Menu. Go to the Fuel Mix Menu and activate it. For a basic setup, that is all that is required. lgNtBKg.